Using emulation mode, Using the help system, Using emulation mode using the help system – Extron Electronics DMS 1600_2000_3200_3600 User Guide User Manual

Page 88: And see

Advertising
background image

DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Matrix Software

82

Using Emulation Mode

Emulation mode allows you to set up the software without attaching the switcher to the
computer. To use Emulation mode, do the following:

1.

Double-click the

Matrix

Switchers

Control

Program

icon in the Extron Electronics

group or folder.

2.

Choose

Emulate

, and click

OK

.

3.

Choose an emulation file to open, and click

OK

. The file DEMO.MTX provides a sample

of a completed matrix setup. Selecting the file NEW.INI or clicking

Cancel

provides a

blank setup to get you started.

4.

Enter the file name under which you want to save any changes to the file, and click

OK

.

5.

Select

DMS

as the Matrix Model (see figure 52) and either

DMS

1600/3600

or

DMS

2000/3200

as the Default Size. Check the boards that are installed; and select the

type, input/output (

4x4

), input only (

4x0

), or output only (

0x4

), for each board. Click

OK

.

Figure 52.

Emulation Mode Configuration

6.

Continue using the program as described on

page 65

.

Using the Help System

For information about program features, you can access the help program in any of the
following ways:

•

From the Extron Electronics program folder or group, double-click on

the MATRIX Switcher Help icon (shown at right).

•

From within the Matrix Switchers Control Program, click the Help menu on
the main screen.

•

From within the Matrix Switchers Control Program, press the <F1> key.

Advertising