Extron Electronics DXP DVI Pro Setup Guide User Manual
Page 20
14
DXP DVI Pro and DXP HDMI Series • Operation
c
Config port — This RS-232 port is an alternative to the rear panel
Remote RS232/RS422 connector. It supports RS-232 only. For more
information about the Config port, see "
in the "Setup" section.
d
Enter button — The Enter button has three primary functions:
•
Saves changes that you make on the front panel.
•
Indicates that a potential tie has been created but not saved.
•
Indicates that a global preset has been selected to be saved or
recalled but the preset action has not been accomplished.
e
Preset button — The Preset button has two primary functions:
•
Places the switcher in preset saving mode to save a
configuration as a preset, and in preset recalling mode to
activate a previously-defined preset.
•
Indicates when preset saving mode is active (blinks) and when
preset recalling mode is active (lights steadily).
f
View
<
button — The View
<
button has two primary functions:
•
Places the switcher in view-only mode to display the current
configuration.
•
Indicates that the DXP is in view-only mode.
g
Esc
>
button — The Esc
>
button has two primary functions:
•
Cancels operations or selections in progress and resets the
front panel button indicators.
NOTE: The
Esc
>
button does not reset the current
configuration or any presets.
•
Indicates that the escape function has been activated (flashes
once).
h
Video button — The Video button has one primary function:
Selects and deselects video for a configuration that is being
created or viewed. It lights green to indicate that video is
available for configuring or for viewing.
i
Audio button — The Audio button has one primary function:
Selects and deselects audio for a configuration that is being
created or viewed. It lights red to indicate that audio is available
for configuring or for viewing.