I/o buttons – Extron Electronics DXP HDMI User Guide User Manual
Page 22
DXP DVI Pro and DXP HDMI Series • Operation
16
g
Esc > button — The Esc > button does the following:
Primary functions (
❏
):
❏
Cancels operations or selections in progress and resets the front panel button
indicators.
NOTE: The
Esc
>
button does
not reset the current configuration or any
presets.
❏
Indicates that the escape function has been activated (flashes once).
Secondary functions (
•
):
•
In I/O grouping mode, selects group 4 (see “
31).
•
In I/O grouping mode, indicates that group 4 is selected.
•
With the Enter, Preset, and View
<
buttons, selects serial port configuration mode
(see “
Selecting the RS-232/RS-422 Protocol and Baud Rate (Rear Panel)
”
on page
43).
•
Selects 115200 baud for the Remote RS232/RS422 and the RS-232 Config ports
in serial port configuration mode.
•
Indicates that the Remote RS232/RS422 and the RS-232 Config ports are set to
115200 baud in serial port configuration mode.
I/O Buttons
You must select video, audio, or both before creating or viewing a tie or a
configuration. This is done by pressing the Video button (
h
) or the Audio button (
i
).
Primary Functions
VIDEO
AUDIO
Action/indication:
Select or deselect
video.
Green when selected
(DXP DVI Pro and HDMI
models only) Select or
deselect audio.
Red when selected
Secondary Functions
Front panel locks
Action 1:
With Enter, select lock mode 2 or toggle between
mode 0 and mode 2.
Action 2:
Select lock mode 1 or toggle between lock
modes 1 and 2.
Resets
Action:
Perform a system reset.
Port
configuration
Action/
indication:
Select RS-232.
Blink: Selected
Select RS-422.
Blink: Selected
h
Video button — The Video button does the following:
Primary function (
❏
):
❏
Selects and deselects video for a configuration that is being created or viewed,
and lights green to indicate that video is available for configuring or for viewing.