Ip setup, Ip settings/options screen – Extron Electronics DXP HDMI User Guide User Manual

Page 84

Advertising
background image

DXP DVI Pro and DXP HDMI Series • Matrix Software

78

IP Setup

The IP Settings/Options window lets you view and, if connected via the RS-232 or
RS-422 link or logged on via the Ethernet port as an administrator, edit settings unique to
the Ethernet interface. To display the IP Settings/Options window, select

IP

Options

from

the

Tools

pull-down menu.

Figure 78.

IP Settings/Options Window

ATTENTION: Editing the following fields or check boxes on the IP Settings/Options

screen while connected via the Ethernet port can immediately
disconnect your computer from the switcher:

•

IP

Address

•

Gateway

IP

Address

•

Subnet

Mask

•

Use

DHCP

check box

•

Administrator

Password

NOTES:

•

Extron recommends editing the settings on this screen using the RS-232 or

RS-422 link and protecting the Ethernet access to this screen by assigning
an administrator password to qualified and knowledgeable personnel only.

•

When the control program is connected to the DXP via RS-232 or RS-422,
the

Administrator

Password

and

User

Password

fields are not masked. If

a password has been inadvertently changed to an unknown value, you can
look up and, if desired, change a password in this window without knowing
the current password.

See “

IP Addressing

” on page

124 for basic information about IP addresses.

Advertising
This manual is related to the following products: