Item – Extron Electronics FOX II T_R DP User Guide User Manual

Page 14

Advertising
background image

FOX II DP Transmitter and Receiver • Installation and Operation

8

h

Fiber optic ports and LEDs —

WARNING: Potential vision damage — These units output continuous laser

light, which may be harmful to the eyes; use with caution.

•

Do not look into the rear panel fiber optic cable connectors or into the fiber
optic cables themselves.

•

Plug the attached dust caps into the optical transceivers when the fiber cable is

unplugged.

NOTES:

•

Ensure that you use the proper fiber cable for your transmitter and receiver
pair. Typically, singlemode fiber has a yellow jacket and multimode cable has an
orange or aqua jacket.

•

Only one fiber optic cable, transmitter-Tx-to-receiver-Rx, is required for video,
audio, and serial command transmission.

But, if you connect only one fiber

optic cable:
The digital video signal output by the receiver

is not HDCP-compliant.

You

will not receive RS-232 reports from the controlled device.

To receive responses from the controlled device and for HDCP compliance, you
must install both fiber optic cables.

é

Tx (required) — For all one-way video, audio, and serial

Transmitter

to

Receiver

OPTICAL

Rx

Tx

LINK

LINK

OPTICAL

Rx

Tx

LINK

LINK

8a

8b

communications from the transmitter to the receiver, connect a
fiber optic cable to the Tx LC connector.
Connect the opposite end of this fiber optic cable to the Rx LC
connector on the FOX II DisplayPort receiver (see

item

l

on

figure 4 and on page 9) or to any other compatible Extron FOX
device.

è

Rx (optional) — For all one-way return video, audio, and serial

communications from the receiver to the transmitter, connect a
fiber optic cable to the Rx LC connector.
Connect the opposite end of this fiber optic cable to the Tx LC
connector on a FOX II R DP receiver (see

item

l

on figure 4 and

on page 10) or to any other compatible Extron FOX device.
Tx Link and Rx Link LEDs — When lit, the link is active (light is

sensed).

i

DC power input — Plug the included external 12 VDC power supply into this

POWER

12V

1.2 A MAX

connector. The LED indicates power is applied. See

Power supply wiring

on

page 15, to wire the connector.

Advertising