Receiver connections, Eceiver (see, Item – Extron Electronics FOX II T_R DP User Guide User Manual
Page 16: On figur, Rear panel, Back to the transmitter (connector, Displayport connector
FOX II DP Transmitter and Receiver • Installation and Operation
10
Receiver Connections
Rear panel
FOX II R DP
DISPLAYPORT
RS-232
RS-232
IR
ALARM
Tx Rx
Tx Rx
1 2
G
Tx Rx
G
POWER
12V
1.2 A MAX
OPTICAL
LINK
LINK
Rx
Tx
L
R
L
R
AUDIO
OUTPUTS
AUDIO
RETURN IN
REMOTE
OVER FIBER
13
18
17
12
15
16
14
19
Figure 4.
FOX II DP Receiver Rear Panel Connections
l
Fiber optic ports and LEDs —
WARNING: Potential vision damage — These units output continuous laser
light, which may be harmful to the eyes; use with caution.
•
Do not look into the rear panel fiber optic cable connectors or into the fiber
optic cables themselves.
•
Plug the attached dust caps into the optical transceivers when the fiber cable is
unplugged.
NOTES:
•
You can connect the transmitter a receiver in either of two ways:
•
One way (transmitter-Tx-to-receiver-Rx) only — Connect fiber cable
12a
(from transmitter connector
é
) only.
•
Two way (transmitter to receiver and return) — See figure 5. Connect
fiber cable
12a
(from transmitter connector
é
to the receiver) and fiber cable
12b
back to the transmitter (connector
è
).
•
See the transmitter fiber connector
on page 8, which also apply to
these connectors.
12a
Rx (required) — For all one-way video, audio, and serial
communications from the transmitter to the receiver, connect
a fiber optic cable to the Rx LC connector.
Connect the opposite end of this fiber optic cable to the Tx
connector on the FOX II T DP transmitter (see
page 8) or to any other compatible Extron fiber optic device.
12b
Tx (optional) — Connect a fiber optic cable to the Tx LC
connector for all one-way return serial communications from
the receiver to the Rx connector on the transmitter.
NOTE: The Tx connector emits light when the
unit is powered and the Rx port receives light.
Connect the opposite end of this fiber optic cable to the Rx
connector on the FOX II T DP transmitter (see
on page 8).
Tx Link and Rx Link LEDs — When lit, the link is active (light is received).
m
DisplayPort Output connector — Connect a video display to this
DISPLAYPORT
DisplayPort connector.
OPTICAL
LINK
LINK
Rx
Tx
OPTICAL
LINK
LINK
Rx
Tx
Transmitter
(
on
page 8)
(
on
page 8)
Receiver
12a
12b
12b
12a
8a
8b