Extron Electronics FOX II T_R DP User Guide - Manual (Page 39)

FOX II DP Transmitter and Receiver • Remote Control 33
Configuration > Input/Output Configuration screen
The Input/Output Configuration screen allows you to set the input and output option
features of the transmitter (see figure 19, below) and receiver (see
figure 20 , on page 35).
Select this screen by clicking the Input/Output Config subtab from either the Status or
EDID Minder screen or Configuration > Input/Output Config from one of the Hardware
screen.
Transmitter Input/Output Configuration screen
1
2
3
4
8
6
7
5
Figure 19. Input/Output Configuration Screen for the Transmitter
a
HDCP Authorized checkbox — Select for the transmitter to act as an
HDCP-authorized device. Deselect if you do not desire the transmitter to
act as an HDCP-authorized device. An HDCP authorized device allows an HDMI source
to output HDCP-encrypted video.
A non-authorized setting is useful for video sources that always encrypt their output if
the connected device (the transmitter in this example) is HDCP capable. If the display
connected to the receiver is not HDCP compliant, this automatic encryption would
result in no display.
b
HDCP Notification radio buttons — Select either the Green or Black
radio button to select how the transmitter displays HDCP notification on a
monitor connected to its Loop-through output port.
The HDCP notification function in the transmitter enables a connected display to show a
green or black screen if the transmitted video is HDCP encrypted, and the display is not
HDCP capable.