Extron Electronics FOX II T_R DP User Guide - Manual (Page 41)

FOX II DP Transmitter and Receiver • Remote Control 35
Receiver Input/Output Configuration screen
1
2
3
4
5
6 7
Figure 20. Input/Output Configuration Screen for the Receiver
a
HDCP Notification radio buttons — Select either the Green or Black
radio button to select how the receiver displays HDCP notification on a
monitor connected to its DisplayPort Output port.
b
Video Shutdown Delay drop-down box — Click the Video Shutdown
Delay drop-down box to set the video shut down delay. This setting
delays the digital video to help the monitor sync correctly during an
input rate change.
Only video is delayed; embedded audio is not
delayed.
c
Video Mute button — Click this button to toggle the video mute on and off
for the receiver DisplayPort output port. Video mute sends black video while
maintaining sync timings from the input video signal. Embedded audio continues to be
output.
d
Sync Mute button — Click this button to toggle the video mute on and off
for the receiver DisplayPort output port. Sync mute disables the sync output,
allowing the display to go blank and, eventually (depending on the timeout parameters
set in the connected display) go into standby or sleep mode. Embedded audio is also
muted.
NOTE: Video Mute cancels Sync Mute and Sync Mute cancels Video Mute .