Creating i/o groups – Extron Electronics HDXP Plus Series User Guide User Manual

Page 33

Advertising
background image

HDXP Plus Series Switchers • Operation

27

Suggested applications for the I/O grouping feature include:

•

Segregating specific video formats to prevent an input in one video format from
being inadvertently applied to an output device that supports another video format
(see figure 37).

•

Segregating input and output devices that are in separate rooms.

•

Isolating video from being displayed on specific output devices for operational security
reasons.

NOTES:

•

Presets can be created under RS-232, RS-422, or Ethernet control to tie inputs
and outputs across group boundaries. These presets

are selectable from the

front panel.

•

An input or output can be assigned to only one group. If you assign an input
or output to a group, and that input or output is already assigned to a different
group, the older grouping is replaced by the new grouping.

•

For I/O groups to have any function, at least two groups must be created.

Creating I/O groups

Follow these steps to create I/O groups using the front panel:

NOTE: The illustrations in this section show the HDXP 3216. However, the procedure

applies to all three HDXP models.

1.

Press the Esc

>

button to clear any input buttons, output buttons, or control buttons

that may be lit. The Esc

>

button blinks once, then turns off.

CONTROL

PRESET

ENTER

ESC

VIEW

Press the Esc

>

to clear all selections.

The button blinks once.

Figure 37.

Clearing All Selections

2.

To enter I/O grouping mode, press and

hold the Input 1 and Output 1 buttons

simultaneously, until the buttons for all the ungrouped inputs and outputs light green
(approximately 3 seconds). If no groups have been formed,

all the input and output

buttons light.

1

1

1 2

17 18

17 18

1 2

1 2

1 2

Press and

hold the

Input 1 button and
the Output 1 button.

Release the Input 1 button
and the Output 1 button.

Ungrouped input and
output buttons light.

3 Seconds

Outputs

Inputs

Figure 38.

Selecting I/O Group Mode

Advertising