Extron Electronics MPS 602 Series User Guide - Manual (Page 17)

Cabling the MPS 602 Switcher
The MPS switcher can be connected to as many as six input devices. It can output to one
of two outputs (HDMI or DTP). Follow the steps below and the installation example (see the
MPS 602 Application Diagram on page 11)
1. Turn off power to the MPS switcher and all devices that will be connected to it.
2. If the MPS switcher is rack, table/wall, or through-desk mounted, position the brackets
and install the mounting screws (see
Mounting the Switcher on page 33).
3. Attach up to two analog, three HDMI (or DVI-D with appropriate adapters) sources,
and one DTP transmitter device to the switcher (see
Rear Panel Connections on
page 5).
4. Connect the switcher HDMI output to a compatible display device, or the DTP output to
a compatible DTP receiver (see
Rear Panel Connections on page 5).
5. For stereo audio input, connect up to six audio sources to the corresponding audio
inputs of the analog (1 and 2), HDMI (3 through 5), or DTP (6) video groups (see
Rear
Panel Connections on page 5).
6. For vocal input, connect a mic to the Mic/line input (see Rear Panel Connections on
page 5). Set the phantom power switch if necessary.
7. For output, connect an appropriate audio output device depending on the switcher
model:
• All models – Connect an audio amplifier to the program or fixed Audio Output
connectors (see
Rear Panel Connections on page 5).
• MPS 602SA – Connect stereo speakers to the speaker output connections.
• MPS 602MA – Connect a 70V line speaker system to the speaker output
connections.
NOTE: The program and fixed outputs are on all models. On models with
internal amplifiers the outputs are used exactly as they are on non-amplified
models.
8. Connect a control PC or controller to the switcher using:
• The rear panel RS-232 port and a 3-pole captive screw connector ( k ) (see
Remote Control Port (RS-232) on page 22).
• The front panel USB configuration port (see Front Panel Configuration Port on
page 23).
9. Power up the input and output devices, then connect power to the rear AC connector
of the switcher (see
Rear Panel Connections on page 5).
MPS 602 • Installation 11