Extron Electronics MPS 602 Series User Guide User Manual
Page 32
X1!
= Input select 0 through 6 (0 = deselect)
X1@
= Program audio ducking level in talk-over mode in dB (0 to 30,0 = off)
X1#
= Audio input gain/attenuation in dB (-18 to +24, in 1 dB steps)
X1$
= Audio input gain in dB (0 to 24, in 1 dB steps)
X1%
= Audio input attenuation in dB (1 to 18, in 1 dB steps)
X1^
= EDID slot number from lookup table (see
1-56 = factory EDIDs,
57 = VGA automatic mode slot (default for VGA inputs)
58 = HDMI/DTP automatic mode slot (default for HDMI/DTP inputs)
59-64 = user loaded EDID slots
X1&
= Raw EDID HEX value: 128 or 256 Byte (text form)
X1*
= EDID native resolution and refresh rate
X1(
= Device name (default: MPS-
602)
Name is a text string of up to 24 alpha-numeric characters and a minus sign or hyphen (-). No
blank or space characters are permitted. No distinction between upper and lower case. The first
letter must be a letter, and the last character must not be a minus sign or hyphen.
X2)
= Input HDCP status:
0= No source connected
1=Source connected and is HDCP compliant
2=Source connected but no HDCP
X2!
= Output HDCP status:
0= No sink detected
1=Sink detected with HDCP
2=Sink detected with no HDCP
X2@
= Input audio format:
0=Extract embedded digital audio
1=Use analog audio input instead of embedded digital audio
2=Auto select. Embedded audio takes priority over analog audio.
X2#
= Executive mode state:
0=off
1=front panel lockout
2=mic only lockout
X2%
=
48V phantom power
0=off
1=on
X2^
= HDMI audio mute
0=off/unmuted (default)
1=on/muted
X2&
= Video output selection switch status
0=DTP
1=HDMI
X2*
= Input auto switch mode
0=disabled (default)
1=enabled (highest active input has priority)
2=enabled (lowest active input has priority)
X3)
= Pixel phase
0 to 63 (default=32)
X3!
= Total pixels
+255 of the default value depending on input rate
X3@
= Horizontal or vertical start
0 to 255 (default=128)
X3$
= Verbose mode
0=clear/none.
1=verbose mode (default).
2=tagged response for queries.
3=verbose mode and tagged response for queries.
MPS 602 • Remote Communication and Control
26