Extron Electronics MPS 602 Series User Guide - Manual (Page 9)

• Audio breakaway — Provides the capability to break an analog audio signal away
from its corresponding video signal and route to the audio outputs, allowing the analog
audio channels to be operated as a separate switcher.
• Output volume control — Provides volume control and muting for the program and
amplified audio outputs, as well as a separate control for mic volume and muting.
• Available with energy efficient Class D stereo or mono amplifier:
• 2 x 50 watts @ 4 ohms; 2 x 25 watts @ 8 ohms
• 1 x 100 watts @ 70 volts — The MPS 602 SA offers a stereo power amplifier with
50 watts per channel into 4 ohms and 25 watts per channel into 8 ohms, while the
MPS 602 MA offers a mono 70 volt power amplifier with 100 watts rms output.
Both feature an Extron exclusive, highly efficient, advanced Class D amplifier design
with CDRS - Class D Ripple Suppression, an Extron patented technology that
provides a smooth, clean audio waveform and an improvement in signal fidelity
over conventional Class D amplifier designs. CDRS eliminates the high frequency
switching ripple characteristic of Class D amplifiers, a source of RF emissions which
can interfere with sensitive AV equipment such as wireless microphones.
• Auto-switching between inputs (Auto Switch) — Allows for simple, unmanaged
installation in locations such as in a lectern or under a conference table. When multiple
inputs are active, the switching priority is configurable.
• Front panel security lockout — Locks out either all front panel functions, or mic
volume and muting; all functions however, are available through USB or RS-232 control.
• RS-232 control port — Enables the use of serial commands for complete control
and configuration via the Extron Windows
® -based control program, or integrated into
a control system. Extron products use the SIS - Simple Instruction Set command
protocol, a set of basic ASCII commands that allow for quick and easy programming.
• Front panel USB configuration port — Enables easy configuration without having to
access the rear panel.
• RJ-45 signal and link LED indicators for DTP port — Provides a means for
validating signal flow and operation from transmitter or receiver, allowing quick
identification of connectivity issues.
• Rack-mountable 1U, full rack width metal enclosure
• Includes LockIt HDMI cable lacing brackets
MPS 602 • Introduction 3