Extron Electronics MLC 104 SIS Programming and Control - Manual (Page 30)

SIS ™ Programming and Control, cont’d
MLC 104 Series • SIS ™ Programming and Control 5-30
PRELIMINAR
Y
Command/r
esponse table for SIS commands (continued)
Command
ASCII
(T
elnet)
URL Encoded (W
eb)
Response
Additional description
(host to switcher)
(host to switcher)
(switcher to host)
Read button LED status
Esc
LC
W LC
|
X212
Set button LEDs to blink slowly
24
Esc
1*
X212
LX
W 1%2A
X212
LX
|
Lbk*1*
X212
Read which button LEDs ar
e set to blink (whether slowly or fast)
Esc
1LX
W 1LX
|
X212
Set button LEDs to blink fast
24
Esc
2*
X212
LX
W 2%2A
X212
LX
|
Lbk*2*
X212
Read which button LEDs ar
e set to blink fast
Esc
2LX
W 2LX
|
X212
The command to make a button LED blinik fast takes precedence over the comand to make it blink slowly
. If a button’
s LEDs ar
e
set to blink both fast and slowly
, the LED will
blink fast.
Reset (zap) commands and erase commands
Erase the flash memory
24
Esc
ZFFF
WZFFF
|
Zpf
Reset all device settings to factory defaults
24
Esc
ZXXX
WZXXX
|
Zpx
The “reset all settings” command does
n
o
t a
ffect IP
settings or flash memory
.
The ZXXX command does not reset any IP-r
elated settings such as the IP addr
ess, subnet mask, and gateway IP address. It also d
oes not affect user files stor
ed in flash memory.
Absolute system r
eset
24
Esc
ZQQQ
WZQQQ
|
Zpq
Reset
all
settings/memories.
The ZQQQ
command r
esets everything (all settings,
adjustments, PINs, the IP addr
ess, and
subnet mask) to the factory default values. Files in flash memory are also erased by this command. The firmware version doesn’t change. The IP
address is reset to 192.168.254.254,
the subnet mask is reset to 255.255.0.0. This command is identical to reset mode 5, discussed in “Resetting the unit” in chapter 2.