NXG Technology NX-RM505 - Manual (Page 43)

12. Cloning NX-RM505
1 Go to the SETUP mode by pressing the MAIN and ENTER buttons
simultaneously for three seconds. 2. Press the CLONE button next to
the LCD screen.
3 Press either the SEND or RECV button depending upon the role of
the remote control. If the NX-RM505 is to be copied from, press the
SEND button. If it is to be copied to, press the RECV button.
4 If you wish to clone the entire device, press the ALL button. If you
wish to clone only one device at a time, Press the DEVICE button.
5 If you press the DEVICE button, it will show all the devices. Press the
device button you wish to clone.
6 Set the NX-RM505 head to head with another NX-RM505 to be
cloned from as shown below. Each unit should be in either cloning
from or cloning to mode based on the above steps.
NX-RM505
43
NX-RM505_Remote_Manual 10/6/08 6:17 PM Page 43