NXG Technology NX-RM505 - Manual (Page 8)

3. Summary of Operations
SYSTEM OFF buttons can be made ‘system-wide’ if they are pro-
grammed with macros.
(Note: Programming the POWER or SYSTEM OFF buttons with a
macro overrides the pre-programmed or learned code on the but-
ton.) See page 26 of this manual for further information. Each of
these five buttons is designed to be able to send out a series of up
to 20 commands you program into the buttons. One common use
is to turn on and turn off all of your A/V components with one but-
ton press, but the buttons can be programmed with whatever
macro you desire.
Ten Device Buttons
There are ten device buttons and each of these device buttons can
send out a series of up to 20 programmed commands when
pressed for more than one second. These buttons are commonly
used in sending audio input codes when you press the button to go
to a device. The audio receiver would make an automatic input
switch according to the device button you pressed. However, these
buttons can be programmed with whatever macro you desire.
E. Favorite Channel Buttons
You can create up to 50 favorite channel buttons in the NX-RM505
by programming the most frequently watched channel numbers
into these buttons. Each of these buttons can send out up to 10
commands. Please refer to page 24 of the manual for Favorite
Channel Programming.
F. Punch Through Operations
The NX-RM505 can be set up to operate your audio component
volume control buttons (VOLUME UP and DOWN and
NX-RM505
8
NX-RM505_Remote_Manual 10/6/08 6:17 PM Page 8