1introduction, 2 rcu interior (figure 1.3) – Alpha Technologies CFR Redundant Control Unit User Manual
Page 6
4
1
Introduction
1.2
A Tour of the RCU
1.2.2
RCU Interior (Figure 1.3)
Front Panel:
This hinged panel opens downward to allow the operator access to the RCU interior to
configure the input/output voltage, replace fuses or for troubleshooting. Two, 3.15 Amp
fuses are located here.
Contactors:
The primary and secondary contactors.
Sliding Panel:
This panel slides back and forth for access to the RCU’s input, output and alarm terminal
blocks.
Input 1 Terminal Block:
This terminal block is the primary power input.
Input 2 Terminal Block:
This terminal block is the secondary power input.
Output Terminal Block:
This terminal block is the RCU’s output.
Alarm Terminal Block:
This terminal block is the RCU’s alarm connection.
Power Board:
The RCU is configured here for 120, 208 or 240 VAC operation. Two, 500 mA fuses are
located on this board.
1
2
4
6
3
5
7
8