Alpha Technologies CXDS-M 600_600-19 - Manual (Page 28)

9400002-J0 Rev A 26
5.5 External Alarm Wiring
If using the alarm outputs from the CXCP relays, route the signal cable as shown in Figure 16 ,exiting through the
knockout in the top BDFB. Refer to the controller software manual to set up the alarms.
Figure 16 — Route of external signal wiring
WARNING!
To prevent electrical hazards such as short circuits, ensure that the system is free of
debris such as metal filings, screws, etc., after the installation is complete.