Alpha Technologies PWE-6FT - Manual (Page 15)

15 031-259-B0-001, Rev A
2.0 Installation
The PWE-6FT can be mounted on wooden, concrete or steel utility poles. Most codes require the base
of the enclosure to be located a minimum height from the ground. Always verify height restrictions before
proceeding.
2.1 Wooden Pole Installation
Never transport the unit with batteries installed. Batteries must ONLY be installed after the unit
is installed. Transporting the unit with installed batteries may cause injury to installer and/or
damage to enclosure and installed equipment.
Alpha recommends positioning enclosure on the opposite side of the pole from oncoming traffic. This can reduce
the danger caused by falling equipment in the event that a pole is struck by an automobile.
Mounting bolts must go completely through the wooden pole and be secured from the back with a large washer
and nut.
The majority of poles are the property of the local utility company. Before installing an enclosure, the location
and method of mounting must be approved by the utility company.
Materials required: (customer supplied)
• Two 5/8" diameter machine bolts (UNC thread); SAE (Grade 5 or better), length to suit pole
• Two 5/8" diameter zinc-plated flat washers
• Two 5/8" diameter hex nuts (UNC thread)
Tools required: (customer supplied)
• Auger or drill for boring 3/4" diameter holes in the wooden pole
• Mallet or hammer
• Assorted sockets or wrenches
Procedure:
1. Unpack the enclosure and galvanized brackets; turn the enclosure facedown on a soft
surface.
2. Slide one bracket up through the lower mounting straps on the rear of the enclosure. The
bracket’s flanges face away from the enclosure. Secure the lower mounting brackets using
the 3/8" x 3/4" hex bolt.
3. Mark the position for the upper mounting bracket on the utility pole. Drill a 3/4" hole
completely through the pole. Secure the bracket with a 5/8" machine bolt, washer and nut.
Do not fully tighten the bolt at this time.
4. Position the enclosure on the upper mounting bracket. It may be necessary to slightly rock
the enclosure and pull downward to properly seat it on the bracket. Center the enclosure on
the pole.