Alpha Technologies PWE-6FT - Manual (Page 30)

30 031-259-B0-001, Rev A
2.0 Installation, continued
2.5 Connecting the Utility Power, continued
2.5.3 Connecting Coaxial Cable
4. Insert Coaxial Termination into Output Port on bottom of SPI.
Seizure Screw
Assembly
Side View
of
SPI Case
Circuit
Board
Stinger
Output Port
Coaxial Termination
4
T o prevent injury, DO NOT remove SPI cover until all sources of power have been removed.
1. Verify SPI IS NOT connected to power supply.
2. Remove the two screws holding cover onto SPI chassis.
3. Remove SPI cover, exposing circuit board and seizure screw assembly.
Seizure
Screw
Assembly
2
3
1