Atec Agilent-8563E User Manual
Atec Equipment
Advertising
Table of contents
Document Outline
- Title Page
- Table of Contents
- 1 Equipment Required
- Required Equipment
- 2 Operation Verification
- 3 Service Software
- Required Test Equipment
- Installing the ESG_B or ESG_APDP Service Software
- Uninstalling the Software
- ESG Family Support Software Administration
- Running the Service Support Software
- Starting the Software
- Identifying the DUT
- Selecting Performance Tests or Adjustments and the Test Equipment
- Defining the Location where the Test Results are Saved
- Running the Tests and Adjustments
- Reviewing the Test and Adjustment Results
- Printing the Test and Adjustment Results
- Exiting the Software
- 4 PerformanceTests
- Support Software
- 1. Internal FM Accuracy and Distortion
- 2. Internal AM Accuracy and Distortion
- 3. Phase Modulation Accuracy and Distortion
- 4. FM Frequency Response
- 5. AM Frequency Response
- 6. Phase Modulation Frequency Response
- 7. DCFM Frequency Offset Relative to CW
- 8. Residual FM (ESG-A and ESG-D only)
- 9. Harmonic, Subharmonic, and NonharmonicSpuriousSignals
- 10. Power Level Accuracy
- 11. Timebase Aging Rate
- 12. Digital Modulation Level Accuracy
- 13. Internal Digital Modulation Quality
- 14. Custom I/Q RF Modulation Quality (OptionUN8only)
- 15. I/Q Modulation Quality (Options UN3, UN4 & UN8)
- 16. Pulse Modulation On/Off Ratio
- 17. Burst Modulation On/Off Ratio (ESG-D only)
- 18. CDMA Adjacent Channel Power (Option UN5 only)
- 19. Alternate Timeslot Power Settling Time (OptionUNAonly)
- 20. Pulse Rise/Fall Time (Option 1E6 only)
- 21. Measuring Phase Noise and Residual FM (ESG-APandESG-DPSeriesSignalGenerators)
- 22. Dual Arbitrary Waveform Generator Check (OptionUNDonly)
- 23. GSM Loopback BER Check (Option 300 only)
- 24. Frac-N Check (ESG-AP,ESG-DPonly)
- 25. Sampler/YO Driver Check (ESG-AP,ESG-DPonly)
- PerformanceTest Records
- 5 Adjustments
- Adjustment Relationships
- Internal Reference Oscillator Adjustment
- Analog Bus ADC Calibration
- Pretune Calibration
- Internal Source Calibration
- VCO Bias Potentiometer Adjustment
- Lock Angle Potentiometer Adjustment
- KV versus Frequency Calibration
- AM Audio Path Offset Calibration
- Timebase DAC Calibration
- FM Scale DAC Offset Calibration
- FM Path Offset Calibration
- FM In-Band DAC Offset Calibration
- FM Inverting Amplifier Offset Calibration
- FM 1/2 Path Ratio Gain Calibration
- Modulation Source RelativeGainCompressionCalibration
- FM Out-of-Band Calibration (ESG-AandESG-Donly)
- FM Delay Potentiometer Adjustment
- Wide Bandwidth Phase Modulation Calibration
- FM/PM Out-of-Band Calibration
- FM/PM YO Frequency Compensation Calibration
- DCFM Calibration
- Low Frequency (LF) Output Calibration
- External Input Peak Detector Calibration
- Burst Modulator Calibration
- Burst Audio Path Gain Calibration
- Prelevel Calibration
- Prelevel Calibration, Analog (ESG-Aonly
- Gain Adjust Calibration
- Low Noise Floor Gain Adjust
- ALC Modulation Driver Bias Calibration
- VBLO Mixer Bias Calibration
- Power Level Accuracy
- Level Meter Calibration
- ALC Modulation Flatness Calibration
- AM Gain Calibration
- I/Q Gain/Offset/Quadrature Calibration
- I/Q Impairment Adjustment
- Baseband Generator I/Q Gain and Offset Adjustment
- 6 Maintenance and Service
- 7 Safety and Regulatory
- Index