Atec Kepco-KLP Series - Manual (Page 5)

KLP/KLR PROGRAMMING CHARACTERISTICS - LOCAL
SPECIFICATION RATING/DESCRIPTION CONDITION
Local Control Rotary encoders Panel mounted
Local Control Coarse ~100 LSB/step Depress control for fine resolution
Resolution
Fine 1 LSB/step
Setting Range 0-100% of rating KLP will automatically adjust limit to maintain 1200W maximum
Power Up Voltage Defaults to zero Last setpoint values may be saved for voltage and current
prior to unit shutdown, and recall them when unit is next turned on Settings
Current Defaults to min value
Protection Overvoltage 20-120% of E max Programmable; accessed via front panel
protect switch or SCPI command over digital bus Limits
Overcurrent 72-120% of I
max
KLP/KLR PROGRAMMING CHARACTERISTICS - DIGITAL
SPECIFICATION RATING/DESCRIPTION CONDITION
Supported Standard GPIB and RS 232 Supports SCPI command set for
Interfaces Models GPIB and RS 232
E-Series GPIB and LAN Support SCPI command set for
Models Support four interfaces for LAN: GPIB and LAN
Web interface, port 80
SCPI Telnet, port 5024
SCPI Sockets, port 5025
VXI 11, port 1024
GPIB GPIB address range: 1 to 30 Factory default is 6
RS 232 Standard Baud rate range: 2400, 4800, Factory default is 38,400
Models Only 9600, 19,200 or 38,400
Digital Remote Isolation Safety Extra Low Voltage (SELV)
Control
Format Compatible with SCPI protocols W98 SE and later operating systems
Programming Resolution 0.024% of E max and I max
Programming Accuracy 0.05% of E max and I max
Readback Resolution 0.024% of E max and I max
Readback Accuracy 0.1% of E max and I max
Status Reporting OVP, OCP, OTP, Output Lead Fault (OLF),
fan failure, source power loss
KLP/KLR PROGRAMMING CHARACTERISTICS - ANALOG
SPECIFICATION RATING/DESCRIPTION CONDITION
Analog Remote Selection Activate with jumper at analog Recognized during power up
Control programming connector
Isolation Safety Extra Low Voltage (SELV)
Analog Input 2Hz (0.5 Second) applies to programming by Analog input voltage digitized (12-bit resolution), optically
Update Rate voltage/resistance and readback specifications isolated, then processed by digital section
Programming Voltage 0-10V Voltage equivalent to Full Scale
By Voltage can be reduced by the user
Current 0-10V See Model Table for minimum programmable current.
Voltage equivalent to Full Scale can be reduced by the user
Programming Voltage 0-10K ohms Resistance equivalent to Full Scale
By Resistance can be reduced by the user
Current 0-10K ohms See Model Table for minimum programmable current.
Resistance equivalent to Full Scale can be reduced by the user
Readback 0-10V proportional signal Proportional to analog control voltage/resistance
Remote inhibit TTL compatible Dual polarity, can be active (inhibit
the output) for either a TTL high or low
Composite Status Flag Isolated form C contacts Programmable. Flags system fault.
Additional user selectable flag: a) transition from CV to CC mode
or b) transition from CC to CV mode.