B&K Precision 1900-1901-1902 - Manual - Manual (Page 21)

19
5. Switch on the power supply.
6. Check the output voltage range of the power supply by varying the external
voltage source for voltage adjustment from 0 to 5 V.
7. Short circuit the main output with an 8AWG gauge wire and check the
display for CC setting by varying the external voltage source for current
adjustment from 0 to 5 V.
8. Switch off the power supply.
Method B: Using Two 5 kΩ Variable Resistors
1. Make sure the load is disconnected and the power supply is OFF.
2. Prepare two 5 kΩ variable resistors and connect wires from pins 1, 2, 3, and
4 as shown in Error! Reference source not found..
Figure 7 - Variable 5 kΩ Resistors Setup