B&K Precision 393 - Manual - Manual (Page 13)

13
2 Getting Started
2.1 Using the Digital Multimeter
With no signal present, set the rotary switch to the desired
measurement function. Ensure proper insertion of the test
leads so they correspond with the type of measurement you
wish to perform, see the following instructions to understand
the proper lead configuration for each measurement type.
2.2 DC and AC Voltage Measurements
Turn the rotary switch to the corresponding symbol for the
measurement you would like to perform.
Follow these steps to make a measurement.
1. Connect the negative (-) side with the black test lead to
the COM input.
2. Connect the positive (+) side with the red test lead to
the VΩHz%ns input.
3. Probe with the test leads to the DUT and take the
measured reading on display.
Figure 2 - Connection for AC or DC Voltage Measurement
WARNING:
Never connect more than 750 V AC or 1000 V DC
across the input terminals.
20A uAmA
COM V.Ω
AC or DC
+ -
V