Dialight SafeSite High Bay ATEX/IECEx - Manual (Page 3)

Dialight - LED Solutions for Industrial and Hazardous Applications
Tel: +44 (0) 1638 665161 – Fax +44 (0) 1638 660718 – www.dialight.com
Conformity with Standards
This equipment conforms to the standards specified in
the Declaration of Conformity.
It has been designed, manufactured and tested in
accordance with BS EN 9001.
94/9 EC: Equipment and protective systems intended for
use in potentially explosive atmospheres.
2004/108/EC:EC Directive for electromagnetic
compatibility.
Equipment Application
This lighting equipment is intended for use in a potentially
explosive atmosphere in Zones 1 and 2 to the
requirements of ATEX Directive 94/9/EC. The product
can be used inside or outside to illuminate areas with
potentially explosive atmosphere.
Installation
Ensure that the mains voltage supply is disconnected
before connecting the luminaire. Install the equipment in
accordance with the manufacturer’s instructions as well
as any other applicable electric codes.
Always transport and store the equipment in its original
packaging and keep in a dry location.
When unpacking check for any cracks or damage in the
housing, glass, and glass frame. If in doubt, do not install!
Electrical Connection:-
COLOURED
CABLE
NUMBERED
CABLE
LIVE BROWN 1
NEUTRAL BLUE 2
EARTH/GROUND GRN/YEL 3
NOTE:- If input voltage is less than 200VAC
maximum ambient operating temperature is +50°C
The improper installation, operation, and maintenance of
these luminaries may result in the invalidation of the
guarantee.
Mounting Luminaire
Assemble the mounting bracket to the Luminaire with 2
M8 x 1.25 by 16mm Bolts. Torque specification: 10.0nm
maximum.
Taking into Operation
Prior to operating, check the luminaire for its correct
installation in compliance with these operating
instructions and other applicable regulations.
Attention: Only fully certified equipment may be put
into operation.
Use the dimensions in figures provided to locate the
luminaire into the desired position. Maximum screw / bolt
size M6 (not provided).
NEVER Open the luminaire. There are no user
serviceable parts inside.
DO NOT remove or tamper with certified cable gland.
The Ex d rated gland has been supplied and installed
to the luminaire accordance with the manufacturers
instructions.
Tampering with this cable gland may compromise
IP66/67 rating and result in flame propagation into
the atmosphere.
Conditions for use:
The supply to the Luminaire must include a fuse which is
capable of interrupting a 1500A short circuit current.
When used with steel wired armor or braided cable the
basket weave armor or braid is unable to carry the cable
load without fracture. Therefore the cable must be
clamped and cleated to prevent pulling on the cable
being transmitted to the cable terminations.
Improper installation and operation of this luminaire may
invalidate the warranty.
For maximum long term reliability and light output, the
luminaire must be installed in free air.
The High Bay fixture design incorporates an over-
temperature control circuit that reduces input power
should internal temperatures reach a maximum level. In
this event light output may be reduced.
Maintenance
NEVER Open the Luminaire. There are no user
serviceable parts inside.
This LED Luminaire should require a minimum amount of
maintenance. If any unforeseen repairs are required then
always observe explosion protection regulations and
requirements.
IMPORTANT