Dialight HBXREF22 DuroSite LED High Bay - Manual (Page 2)

Document No: 9100-127-1532-99 Rev A
Page 2 of 4
1501 Route 34 South, Farmingdale, NJ 07727
Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com
1: Introduction
This Acrylic Reflector kit provides several advantages including glare reduction when side viewing,
up lighting and aesthetics for retrofit installations.
Part Number Description of Reflector
HBXREF22 22” Acrylic Reflector
Note: Save these instructions for future reference.
2: Installation
Warning:
To avoid the risk of fire, explosion, or electric shock, this product should be installed, inspected,
and maintained by a qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock:
• Be certain electrical power is OFF before and during installation and maintenance.
• Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid personal injury:
• Allow the unit to cool down before performing maintenance.
Acrylic Reflector Installation Steps:
• Prior to mounting and electrical connections, place High Bay face down on a stable
elevated surface (at least 8.5” above the table) that does not exceed the outer diameter of
the High Bay. This is so that the reflector will be properly positioned on the High Bay unit.
• Position the Acrylic Reflector over High Bay resting on the outer edges of the fins and feed
the electrical wire through the top of the Reflector.
8.5”