Dialight HBxxMx DuroSite LED High Bay - Manual (Page 2)

Document No: 9100-127-1327-99 Rev R
Page 2 of 12
1501 Route 34 South, Farmingdale, NJ 07727
Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com
Dialight de México S.R.L de C.V. Calle Lirios s/n
Col. Carlos Pacheco, Ensenada Baja California, México C.P. 22830
+52 (646) 156-70-80
1: Introduction
This High Bay light is designed for illumination of industrial locations. It uses the latest in solid state
lighting technology for long life, low maintenance, and high efficiency.
The unique optical design focuses light downward to where it is needed, giving improved efficiency
over a conventional HID luminaire.
An internal power-factor-corrected switch-mode supply allows it to be used from any nominal 100V-
277V, 50/60Hz AC supply without any variation in light output.
Models HB1xxx, HB3xxx, HB5xxx, and HB6xxx are suitable for use in the following locations:
 Dry locations only as per UL 1598
Models HB0xxx, HB2xxx, HB4xxx, HB7xxx, HBGxxx, HBWxxx, and HBLxxx are suitable for use in
the following locations:
 Wet Locations as per UL 1598
 Outdoor Type (Salt Water) as per UL 1598A
Note: Save these instructions for future reference.
“THE ELECTRICAL CHARACTERISTICS OF THE LIGHT FIXTURE ARE
THOSE INDICATED ON THE PRODUCT LABEL”
2: Installation
Warning:
To avoid the risk of fire, explosion, or electric shock, this product should be installed, inspected,
and maintained by a qualified electrician only, in accordance with all applicable electrical codes.
Warning:
To avoid electric shock:
 Be certain electrical power is OFF before and during installation and maintenance.
 Luminaire must be connected to a wiring system with an equipment-grounding conductor.
Warning:
 Make sure the supply voltage is the same as the rated luminaire voltage.
 Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
Recommended mounting height: 25-40 feet