MoTeC LTCN - Manual (Page 2)

2 Introduction
Introduction
MoTeC LTCs (Lambda to CAN) monitor and control Wideband Lambda
sensors and transmit Lambda readings and diagnostics on a CAN bus. There
are single channel LTC and Dual channel LTCD available to suit either Bosch
LSU4.9 or NTK sensors:
• #61300 – Single channel Bosch LSU 4.9 Sensor
• #61301 – Dual Channel Bosch LSU 4.9 Sensors
• #61304 – Single Channel NTK Sensor
• #61305 – Dual Channel NTK Sensors
Up to 32 Lambda sensors can be configured on a single CAN bus using LTCs,
allowing an ECU or Data Logger to simultaneously monitor multiple Lambda
sensors.
Throughout this manual the LTC, LTCD, LTC-N and LTCD-N will be referred to
as LTC except where details specific to a particular model are discussed.
Features
• Accurate Lambda measurement even when the exhaust gas temperature
is changing rapidly (heating or cooling)
• Ability to perform free air sensor calibration or use the initial sensor factory
calibration. LTC-N has the ability to be calibrated against a test gas.
• Pre-configured to work in a single LTC or LTCD installation, without
requiring configuration with a PC
• LTC Manager software to:
o
configure and calibrate all LTCs on the CAN bus
o
display readings and diagnostics
o
configure the CAN transmission address of each LTC
o
control free air calibration
o
update LTC firmware
Compatibility
• MoTeC ‘Hundred series’ ECUs: M400, M600, M800 and M880
• MoTeC M1 Series ECUs
• MoTeC Data Loggers : SDL, SDL3, ADL, ADL2, ADL3, ACL