Castle TSM-21 Serial 61076 to 64233 (Parker) Operator Manual User Manual

Page 22

Advertising
background image



ƒ Turn the Power Switch on (Figure 19).

Figure 19

ƒ Place the work piece to be pocketed on the Work Top. Slide it under the Clamp Guard

and firmly push it against the face plate of the machine to press the Safety Buttons.
(Figure 20)

Figure 20

ƒ Be sure to keep your hands clear of the clamp, then press and release the Foot Pedal to

activate the cutting cycle.

ƒ The pocket will be cut at the point directly under the center of the Clamp Cylinder.

ƒ When the Pocket Cycle has been completed the Clamp Foot will automatically release

the material.

ƒ A typical machine cycle will take from 1½ to 2 seconds to complete.

ƒ Reposition the same work piece or a new work piece under the Clamp Guard, then press

and release the Foot Pedal again to activate the next cutting cycle.

ƒ Be sure to turn off the Power Switch when you are finished.

ƒ

If the machine fails to cycle properly, call Castle at (800) 282-8338

20

Advertising