Castle TSM-21 Serial 61076 to 64233 (Parker) Operator Manual User Manual

Page 29

Advertising
background image

27

9. If the Clamp Foot extends but the cycle stalls with the router extended or if the cycle

skips over the router stroke entirely, inspect the Router Stop Switch (page 31).

10. If the router retracts and the drill extends at an excessive rate, inspect or reset the internal

Pressure Regulator (page 16).

11. If the cycle stalls with the drill extended or if the cycle skips over the drill stroke entirely,

inspect the Drill Stop Switch (page 32).

12. If the cycle takes significantly longer than two seconds to complete, inspect the Air

Supply, the Pressure Regulator (page 30), or the Router Feed Rate Adjustment (page 13).

13. If the Dry Cycle is successful, but a regular cycle fails when routing pockets and drilling

holes, inspect the Tooling (pages 21, 22), or the Motor Operation (Porter-Cable
instruction manual).

14. After Dry Cycling is completed, turn the Power Switch OFF and turn the motor switches

ON (or plug them into the Control Box outlet).


The list of possible behaviors described in Steps 5 through 13 is by no means exhaustive.
Careful observation and description of the cycle behavior is essential when troubleshooting
or seeking Technical Support.

























Advertising