CEMB USA C206 User Manual - Manual (Page 6)

I 0677 - 6
7
9
10
11 12
13
14
15
6
6
6
1 2
3 4
8
6
16
5
GB
4 - CONTROLS AND COMPONENTS
4.1 - CONTROL PANEL AND DISPLAY ►
1-2 Digital readouts, AMOUNT OF UNBALANCE,
inside/outside
3-4
Digital readouts, POSITION OF UNBALANCE,
inside/outside
5
Indicators, correction mode selected
6 Indicators, selection made
7 Push button, unbalance reading < 5 g (25 oz)
8 Push button, ounces/grams selection
9 Push button, selection of mode of correction
10 SPLIT push button (unbalance resolution)
11 Push button, FUNCTIONS MENU
12 Push button, menu selection confi rmation
13 Push button, car/truck selection
14 HOME Push button
15 Push buttons, manual dimensions setting
16 Position repeat
O N LY USE THE FINGERS TO PRESS THE PUSH BUTTONS .
N EVER USE THE COUNTERWEIGHT PINCERS OR OTHER POINTED OBJECTS .
4.2 ► - AUTOMATIC DISTANCE AND DIAMETER GAUGE
This gauge allows measurement of the distance of the wheel from the machine and the wheel diameter at the point
of application of the counterweight. It also allows correct positioning of the counterweights on the inside by using the
specifi c function (see
INDICATION OF EXACT CORRECTION WEIGHT POSITION
) which allows reading the position used
for the measurement within the rim.
4.3 - WHEEL LIFTING DEVICE ►
Allows lifting the wheel from the ground without using a lift in order to spin it.
It also allows lowering the wheel until it touches the ground in order to stop rotation
4.4 - MANUAL SPINNING DEVICE ►
Allows spinning the tyre until when the machine display turns off; this means that the minimum spindle rotation speed
has been reached to perform correct balancing (72’/min. for trucks and 100’/min. for cars). At this point, release the
handle and wait until the unbalance measured appears on the display. If the beep function is enabled (see
MENU
), a
beep will sound when the correct balancing speed is reached.