CEMB USA C206 User Manual - Manual (Page 9)

I 0677 - 9 GB
5.2.2 - ► MODIFYING SET DIMENSIONS
If the wheel dimensions have been entered incorrectly, the parameters can be modifi ed without repeating the balan-
cing spin by pressing :
access parameter modifi cation
→
(select to modify: (a) distance, (b) width, (d) diameter
→
to obtain the new measurement
or:
pull out the gauge to repeat the measurement
→
to obtain the new measurement.
5.2 ► .3 - EXACT POSITIONING OF THE ADHESIVE WEIGHT BY MEANS OF THE GAUGE WITH CLIPS
Press the button if using the correction method with weights on the inside of the rim .
Fit the correction weight in the specifi c gauge seat with the adhesive ■
part facing upwards
Bring the wheel into correct angular position for the plane to be
■
corrected.
Pull the gauge further outwards. ■
Return the gauge to the rest position. ■
INSIDE CORRECTION POSITION ■
OUTSIDE CORRECTION POSITION ■
■ When the weight application distance has been reached a beep is sounded (can be deactivated).
■ rotate the gauge until the correction weight adheres to the rim
■ the fact that the weight application position is no longer vertical is automatically compensated
■ to cancel this function, press button again.