CEMB USA C212 User Manual - Manual (Page 7)

7
Use and maintenance manual Rev. 10-2010
ENGLISH
Starting
3. Starting
WARNING
b
efoRe sWITchING oN The mAchINe
,
mAke suRe ThAT All The
coNNecTIoNs descRIbed IN The
INsTAllATIoN
chApTeR
hAve beeN mAde coRRecTly
.
T
he folloWING opeRATIoNs INvolve A poTeNTIAl RIsk foR
The opeRAToR
,
GIveN The pReseNce of volTAGe oN The
equIpmeNT
. T
he
p
eRsoNAl
p
RoTecTIve
e
quIpmeNT descRIbed
IN The
INsTAllATIoN
mANuAl musT be WoRN ANd WoRk
musT be doNe WITh due cARe ANd ATTeNTIoN
.
o
peRATIoNs mAy oNly be peRfoRmed by A
specIAlIsed TechNIcIAN
.
Before powering the machine, carry out the following
checks:
1. check that the balancing machine touches the floor
at the three support points;
2. make sure that all the parts of the balancer are cor
rectly connected and fixed;
3. make sure that the parameters (voltage and frequency)
of the mains power supply are compatible with those
indicated on the rating plate of the balancer;
4. make sure the power cable is correctly connected;
5. make sure the machine shaft and flange hole are
clean.
cAuTIoN
A
Ny TRAces of dIRT mAy AffecT bAlANcING AccuRAcy
.
6. To switch on the balancer press the switch on the
left-hand side of the machine.
7. Position the wheel on the terminal with the inner part
facing the balancer;
8. Firmly attach the wheel to the balancer shaft using
the lock nut.
9. In the normal version, the pedal controls a mechani
cal brake which facilitates locking the locking ring
and positioning the wheel for correction.
10. At this point, you can read the tyre measurements
and perform balancing.