CEMB USA C212 User Manual - Manual (Page 9)

9
a
b
b
Use and maintenance manual Rev. 10-2010
ENGLISH
5 Use of the wheel balancer
5.1 CAR/TRUCK SELECTION
Press the button ; LED on
→
balancing machine
set in car mode
Press the button ; LED on
→
balancing machine
set in truck mode.
5.2 PRESETTING OF WHEEL DIMENSIONS
The balancing data is set by means of an “intelligent” au-
tomatic gauge; confirmation of the measurement and the
position appear on the display. The round part of the gauge
must rest on the rim where the weight will be positioned.
While the gauge is moving the following appears:
when the measurement has been stored:
a) standard weights: when only one measurement is
made, the machine interprets the presence of a rim with
clip-on weight correction
Use of the wheel balancer
The width value (b) must be set with the buttons
The correct measurement is that which can be measured with
the compass gauge provided.
b) adhesive weights: make two successive measurements
on two correction planes inside the rim.
The balancing machine automatically interprets that the
correction will be made with adhesive weights and the
following appears:
For a different combination of the type or position of the
weights on the rim, use the button.
5.2.1 Modifying set dimensions
If the wheel dimensions have been entered incorrectly,
the parameters can be modified without repeating the
balancing spin by pressing for 2 seconds :
access parameter modification
→
(select to modify: (a) distance, (b) width, (d)
diameter
In the case of standard weights:
(a)distance,(b)width,(d)diameter
In the case of adhesive weights:
(aI) inside distance,(aE) outside distance,(dI) inside
diameter,(dE) outside diameter
press
to confirm and go to the next parameter
→
to recalculate the unbalance
or:
pull out the gauge to repeat the measurement
→
to recalculate the unbalance.