CEMB USA C71 (B) - Manual (Page 13)

d
b
a
9
10
I 0378 - 12 I 0378 - 13 GB GB
6.3 - Manual dimension presetting (Use only in particular cases or for test)
6.3.1 - Steel wheel rims (use for setting dimensions in AUTOCALIBRATION )
- Setting:
Press or
Set with the rated width that, in general, is shown on
the rim, or measure width “b” with the calliper gauge supplied.
- Press the button for more than 2 seconds
- Preset using the nominal diameter “d” indicated on the
tyre
- Press the button for more than 2 seconds
- Preset using distance “a” for the inside of the wheel
from the machine.
N.B.: This setting is also valid for the correction modes
indicated at “STATIC & COMBINED MODES”
6.3.2 - Alu-s rims
0 gauge