CEMB USA C71 (B) - Manual (Page 18)

I 0378 - 18 GB
Err. 24 Distance between the spokes smaller
than 18 degrees.
1. The minimum distance between the spokes where to split the
unbalance must be greater than 18 degrees
2. Repeat the SPLIT function increasing the distance between the
spokes.
Err. 25 Distance between the spokes greater
than 120 degree
1. The minimum distance between the spokes where to split the
unbalance must be smaller than 120 degrees
2. Repeat the SPLIT function increasing the distance between the
spokes.
Err. 26 Distance between the first selected spoke
and unbalance greater than 120°.
1. To perform the SPLIT function correctly, the unbalance must be
inside two spokes no more than 120° apart.
2. Repeat the SPLIT function selecting a spoke nearer the unbalance.
Err.32/
Err.33/
Err.34/
Err.35/
Err.36/
Err.37
Errors related to test functions of the wheel
balancer.
1. Cancel the error and continue using the wheel balancer as normal.
7.1 - Inconsistent unbalance readings
It may occur that after balancing a wheel, when removing it from the wheel balancer and then remounting it, the
wheel is not balanced.
This is not the result of an incorrect indication by the machine, but only of incorrect mounting of the wheel on the
flange, i.e. in the two mountings the wheel has assumed a different position with respect to shaft axis of the wheel
balancer. If the wheel has been mounted on the flange with screws, it may be that the screws have not been tight-
ened correctly in gradual criss-cross manner one after the other, or (as often occurs) holes have been drilled in the
wheel with too wide tolerances.
Small errors, up to 10 grams (0.4 oz), are to be considered normal in wheels locked with a cone: the error is normally
greater for wheels locked with screws or studs.
If, after balancing, the wheel is still unbalanced when refitted on the vehicle, this could be due to the unbalance of
the brake drum or very often is due to the screw holes in the rim and the drum drilled with too wide tolerances. In this
case a readjustment would be advisable using the wheel balancer with the wheel mounted.
8 - Routine maintenance
Before carrying out any operation on the machine, cut the power supply to the machine.
8.1 - Replacing the protection fuses
A protection fuse is fitted on the power board, accessible by dismantling the weight shelf (see Exploded Drawings). If fuses
require replacement, use ones with an identical current rating.
If the fault persists, contact Technical Service.
NONE OF THE OTHER MACHINE PARTS REQUIRE MAINTENANCE .
9 - List of recommended spare parts
(references on exploded drawings)
CODE DESCRIPTION
181198630 Spring 19863P
67M62904A Phase generator board with cable
05PR59195 LEXAN Panel
182185750 Distance gauge spring
681002000 Fuse DM5x20 - 2A
511242101 Bipolar stub switch
86SC59755 Computer board
86SB59758 Cable, automatic rim distance gauge
86SB59757 Cable, automatic diameter gauge
86SB59759 Cable with micro protection
SPECIAL PARTS FOR 230V MACHINES
568007058 Capacitor 70MF 450V Faston screw M8
67M56989C Power board
50FG58735 Stator 230V/50 - 60 Hz