Analog Way OPS300 - Manual (Page 33)

31
Output selection settings
To set up the output, go in the Main Output or Preview Output menu and choose first the adapted format/
resolution, and then the appropriate rate for your screens by using the knob button and the [ ENTER ] button.
Main Output → Output Format → Output rate
Use the native resolution of your screens/projectors in order to obtain the best image quality. In the Preview
Output menu, you can also match the output configuration the Main Output to the Preview Output by checking
the case Sync w/Out 1. It allows you to set up your outputs via the output 1 menu.
Preview output → Sync w/Out 1
Some other settings are available too:
-
Output sync. polarity.
- Gamma: use this feature to set up the output Gamma.
- Flicker Filter (Video Out only): apply a flicker filter on your video output.
- Analog type: set up the type of synchronisation of your Analog output.
- DVI type: set up the type of color space of your Digital output.
- HDCP detection: set up to enable/disable the HDCP detection on the output.
- Background color: add a background color in place of the default black one.
- Test pattern: use test pattern on Main or Preview screen to configure your projectors.
*All changes have to be validated by pressing the [ENTER] button in order to be saved*
Source output selection
Once your inputs all have been configured, the output settings of the OPS300 must be set according to the
machines plugged on your OPS300 main and preview outputs (video projector, preview monitor...).
* NOTE *: if you want to use HDCP content from your sources, be sure to attach HDCP compliant screens
or projectors. If it’s not the case, the output image could be disabled.
* NOTE *: the output status can provide you all information about the output in real time. This feature is
particularly needed when HDCP is used with long cable to be sure that the communication is well handled.
Video Out
The Video Out allows you the same settings as other outputs with some additional specific options:
-
Sharpness: set up the sharpness on the video out image.
- Flicker Filter: apply a flicker filter on your video output to eliminate flickering.
- Under/Over Scan: perform an automatic zoom on the output.
- Adjust: allow you to setup the video out image in H, V position and H, V size.
- Connection: allow you to choose between several output pattern.
In Matrix mode, the menu “ Connection Mode” appears. It allows you to choose recording Output # 1 or # 2.
The Output menu also allows you to generate test patterns. The test patterns are available through the
Output menu and let you quickly and reliably setup your projectors.
1. In the menu section, press the [EXIT/MENU] button and select Output in the menu by rotating the
corresponding knob. Then press the [ENTER] button to enter the Output sub-menu.
2. In the Output sub-menu, select the Test Pattern menu, then select the output (Main or Preview)
on which you want the test pattern to appear by rotating the scroll knob. Press the [ENTER] button
to enter the Test Pattern menu. Choose the test pattern you wish to use in the Test Pattern menu by
rotating the scroll knob, and press [ENTER] . The chosen test pattern will immediately appear on the
selected screen(s).
3. Press the [EXIT/MENU] button twice to return to the main menu.
* NOTE *: be sure to turn the test pattern off to display your sources again.