Analog Way OPS300 - Manual (Page 50)

In the Control Menu, you will find all setup which cannot be classified in the image, layer, input or output
menu.
Version: it indicates the actual software version of the OPS300.
it can help if you need to contact our technical support team.
RS232/LAN: choose your connection type when controling by a R.C.S or an external program.
LAN SETUP: in this menu, you can adjust every settings reluted in the network
HDCP Summary: show all HDCP Inputs/Outputs Status
Sync. Loss: see p.30
Auto Lock: enable/disable the source selection when no-synch are detected
Auto Take : allow the unit to take by itself as soon as it detects a change (source, layer, position...)
Preset Toggle: enable this feature to put you last program on your preview after a TAKE
UT Bar: enable/disable the virtual T-Bar (it will appear in the Main Preview)
Transparent Bkngd: see p.42
Dynamic Fit: see p.41
Preview Id: see p.42
Freeze mode: choose between 2 modes: Single Layer Freeze Mode or All Layers Freeze Mode
Key Locking: enable to lock a part or all your front panel
LCD Brightness: adjust the LCD Brightness
Key Brightness: adjust the Key Brightness
Standby: parameters for the standby mode
Layer parameters : allow you to reset at the original size/position all layers
Erase Memories: erase all image settings: blanckings, colors...
Default values: put every internal values to factory default (except Ethernet values).
Using the Control Menu
48