Analog Way Smart Vu - Manual (Page 32)

1/ In the Input Selection section, press the source button (1-7) of
the source you wish to record as a logo. The source button will start
blinking.
2/ Select the Logos/Frames menu by scrolling through the menu
with the scroll knob, then pressing the ENTER button.
3/ Select Record Logos in the Logos/Frames menu by rotating
the scroll knob, then pressing ENTER. A small white rectangle will
appear on your main display, indicating the logo that will be captured.
4/ Adjust logo size, position, and fine tune key attributes by rotating
the scroll knob and pressing ENTER to memorize logo settings.
5/ Select an empty logo memory (empty logos are indicated in the
sub-menu) to store the logo into. Press the ENTER button. The
Smart Vu will display a progress status bar on the VFD screen.
6/ In the Layer Selection section, press the LOGO button, and select
logo number (1-4) you wish to use. Your logo will appear on the
preview screen above any existing layer on screen.
7/ Press the TAKE button. Your logo will appear on the main display.
The Smart Vu offers a variety of mixer type transitions, including
wipes, fades, and cuts. The transitions, transition times and fade/
wipe effects can all be setup through the Smart Vu Layer menu.
Memorizing logos
Mixer functions
31