Analog Way Smart Vu - Manual (Page 50)

49
IIf you need to use your own Software Control program from a PC
or automation, the device allows communication through an ASCII
code protocol. All commands can be found on the CD-Rom shipped
with the SmartVu in the “Programmer’s Guide” file.
All Analog Way products equipped with an RS232 input are
compatible with Crestron, AMX, Medialon, and most major control
systems. TCP/IP control ports are also available on most Analog
Way products, as standard or as options.
To control an SVU300 product with an External Remote Controller
(PC Software Control - Touch Pad Controller…) follow the indications
below :
1/ First establish an RS-232 communication between the Remote
Control Software and the SVU300, in order to setup the LAN
parameters of the product.
2/ In the “Control” - “SmartVu LAN Setup” menu, configure the
connection of the SVU300 product in UDP mode and setup the Local
and Remote Addresses as well as the Local and Remote Ports in
concordance with your Network.
3/ Configure the TCP/IP address of your External Remote Controller.
In example: 192.168.000.001
4/ Setup the UDP connection of your External Remote Controller in
concordance with your Network.
In example on the Remote Software in the “Control” - “RS232/LAN
Setup” - “LAN/Setup” menu :
5/ Setup the LAN parameters in UDP mode in the “Console” - “LAN
Setup” menu.
In example: RK Address: 192.168.000.002
Remote Address: 192.168.000.010
Gateway Address: 192.168.000.001
RK Port: 10500
Remote Port: 10500
Netmask: 255.255.255.000
6/ Select the LAN communication port in the remote controller
console - “RS232/LAN port” menu.
7/ You can now control your SVU300 product with an External
Remote Controller.
7-3. EXTERNAL PROGRAMMING