Analog Way Smart Vu LE - Manual (Page 27)

It is strongly recommended resetting all of the default values of your Smart Vu LE unit before setting up your
shows and events. To do so, press the EXIT/MENU button and select Control in the menu by rotating the
corresponding knob. Then press the ENTER button to enter the Control sub-menu. Select Default Values by
rotating the scroll knob, and press the ENTER button to enter your choice to restart your Smart Vu LE with
its factory settings. This operation should take approximatly 30 seconds.
Analog Way engineers have developped a handy, user friendly way of identifying machine status on the front
panel, via the use of color codes on the buttons of the machine. All new Analog Way machines use the same
codes, for quick recognition of the status of any device of the range, at any given time.
For the Smart Vu LE , button color codes are as follow :
- Sources on the Main output are indicated in red when active.
- Sources on the Preview output are indicated in green when active.
- Buttons in the layer section turn red or green, depending on whether the selected layer is active in respectively
the Main or Preview window.
- Menu buttons are indicated in green.
- Selecting a button with an available source or function will cause that button to blink green on the preview,
or red once it is on the Main output.
- TAKE button reacts as follows :
- If take function is available, the button will appear in green.
When the take function is active, it will light up red.
4-3. WORKING WITH THE SVU200
Reseting default values
SVU200 color codes
#1 = Source, Layer or Window is on Main
#2 = Freeze enable
#1 = Source or Layer is on Preview
#2 = Function available for modification
#3 = Current output on Matrix Mode
Active Layer or Source for modification on Main
Active Layer or Source for modification on Preview
Solid red:
Solid green:
Blinking red:
Blinking green:
26