Analog Way Smart MatriX User Manual
Page 35
Output selection settings
To set up the outputs, go in the
Output #1
or
Output
#
2
menu and choose first the appropriate
format/resolution, and then the appropriate rate for your screens by using the knob button and the
Enter button.
Output# → Output Format → Output rate
Use the native resolution of your screens/projectors in order to obtain the best image quality.
In the
Output
#
2
menu, you can also synchronise all the changes from the
Output
#
1
to the
Out-
put
#
2
by checking the case
Sync. w/Out 1
. It allows you to set up both outputs at the same time.
Output 2 → Sync. w/Out 1
Some other settings are available too:
-
The Output synch polarity.
-
The Gamma: use this feature to set up the output Gamma.
-
Flicker Filter (Video Out only): apply a flicker filter on your video output.
-
Analog type: set up the type of synchronisation of your Analog output.
-
DVI type: set up the type of color place of your Digital output.
-
HDCP detection: set up to enable/disable the HDCP detection on the output.
-
Background colour: add a background colour in place of the default black one.
-
Test pattern: use test pattern on Main or Preview screen to configure your projectors.
*All changes have to be validated by pressing the
ENTER button in order to be saved*
* NOTE *: The output status can provide you all information about the output in real time. This fea-
ture is particularly needed when HDCP is used thanks to the HDCP status.
Source output selection
Once your inputs all have been configured, the output settings of the
Smart MatriX must be set according to
the machines plugged on your
Smart MatriX main and preview outputs (video projector, preview monitor...).
* NOTE * : If you want to use HDCP content from your sources, be sure to attach HDCP compliant screens
or projectors. If it’s not the case, the output image could be disabled.
Input Sync. Loss Function
Allows to display a frame or a source in case of sync loss of the selected input. To set up the Sync. Loss
function:
Menu → Control → Sync. Loss → Press Input# or Enabled
The selected input must be activated for being visible in case of sync loss.
33