Datamax-O'Neil A-Class Mark II Operator’s Manual - Manual (Page 139)

A-Class Mark II 129
Appendix C
PE Peel Bar Location
Provided as a reference, the drawing below defines the previous peel point of PE models.
PE Printer Peel Point
Media Tension Settings
Provided as a guideline, the parameters below represent recommended applicator media tension
settings.

These numbers do not represent the pull strength of the printer.
Function Requirement
Media Rewind Force:
Applicator Take-Up Must be of uniform tension from 1 – 5 pounds (454 – 2268 grams),
and must not vary more than 20% during operation
Media Unwind:
Steady State
Transient (Start/Stop)
Must be of uniform tension, not to exceed 3 pounds (1361 grams)
Must not exceed 5 pounds (2268 g)
Peel Bar