Datamax-O'Neil VMP-2000 Installation Guide - Manual (Page 8)

6
Mounting Requirements
Datamax-O’Neil VMP-2000 Installation Guide
Mounting Requirements
Use the following information as a guide for orienting and/or mounting your printer:
1 Before mounting the VMP printer, review the documentation supplied with the bracket
you choose to use.
2 The VMP printer can only be mounted based on the angles shown above. Mounting
the printer outside of these angles results in the printer jamming.
3 When possible, secure the hardware to the metal bulkhead or to internal metal vehicle
components.
4 Use Loctite to mount the brackets (contact Loctite for applicable installation
information).
5 Position the printer with adequate room to open the printer and for the paper to exit.
6 Place the printer near the power source (for more information, see Power Cable
Requirements on page 9).
19”
9”
3.5”
12 - 15”
4.5”
(without
bracket)