Dynasonics MFX Series Insertion MagProbe Flow Meter - Manual (Page 36)

Rev. 01/11
-3.2- MFX
3. The ENTER key is pressed from the RUN mode to view the
current software version operating in the instrument.
x Used to access the configuration parameters in the various
menus.
x Used to initiate changes in configuration parameters.
x Used to accept configuration parameter changes.
The MFX software is structured using menus. A Map of the user
interface has been included in the Appendix of this manual. The
Map provides a visual path to the configuration parameters that
users need to access. This tool should be employed each time
configuration parameters are accessed or revised.
The five menus used in the structure of the MFX are as follows:
1.
BSC MENU -- BASIC operations menu. It contains all of the
configuration parameters necessary to program the meter to
measure flow.
2.
OUT1 MEN -- Configures the type and operating parameters of
the ISO-MOD located in Module #1 position.
3.
SEC MENU -- SECURITY MENU utilized for resetting totalizers,
resetting the operating system and revising security passwords.
4.
SER MENU -- SERVICE MENU contains system measurements
that are used by service personnel for troubleshooting
instruments installed on piping systems.
5.
DSP MENU -- DISPLAY MENU used to configure meter display
functions.
PART 3 - KEYPAD CONFIGURATION
Menu
Structure