Dynasonics MFX Series Insertion MagProbe Flow Meter - Manual (Page 38)

Rev. 01/11
-3.4- MFX
PART 3 - KEYPAD CONFIGURATION
PIPE OD -- Pipe Outside Diameter Entry
ENGLSH (Inches)
METRIC (Millimeters)
Enter the pipe outside diameter in inches if ENGLSH was selected
as UNITS; in millimeters if METRIC was selected.
PIPE WT -- Pipe Wall Thickness Entry
ENGLSH (Inches)
METRIC (Millimeters)
Enter the pipe wall thickness in inches if ENGLSH was selected as
UNITS; in millimeters if METRIC was selected.
LINER T -- Pipe Liner Thickness Entry
ENGLSH (Inches)
METRIC (Millimeters)
Enter the pipe liner thickness. Enter this value in inches if ENGLSH
was selected as UNITS; in millimeters if METRIC was selected.
INS DEPTH -- Insertion Depth Entry
ENGLSH (Inches)
METRIC (Millimeters)
Data defaulted to .125
 pipe I.D. No manual entry is necessary.
IMPORTANT NOTE: Charts listing popular pipe sizes have been
included in the Appendix of this manual. Correct entries for pipe
O.D. and pipe wall thickness are critical to obtaining accurate flow
measurement readings.
Pipe Diameter
Pipe Wall
Thickness
Liner
Thickness
Insertion
Depth
IMPORTANT NOTE: Charts listing popular pipe sizes have been
included in the Appendix of this manual. Correct entries for pipe
O.D. and pipe wall thickness are critical to obtaining accurate flow
measurement readings.