Dynasonics MFX Series Insertion MagProbe Flow Meter - Manual (Page 54)

Rev. 01/11
-4.2- MFX
Initialization
1. Connect communications cable, Dynasonics p/n D005-2115-001,
to a PC communication port and point the communicator at the
MFX infrared window, located in the lower right-hand corner of
the meter front panel. Alternately, connect the PC communications
port directly to an optionally installed RS232C or RS485 module
located within the MFX flow meter.
2. Double-click on the ULTRALINK™ icon. The first screen is the
“RUN-mode” screen (see Figure 4.1), which contains real-
time information regarding flow rate, totalizer accumulation,
system signal strength, diagnostic data and the flow meter’s
serial number. The indicator in the lower right-hand corner will
indicate communications status. If a red ERROR is indicated,
click on the Communications button on the top bar. Click on
Communications/Initialize. Choose the appropriate COM port
and interface type. Proper communications are established when
a green OK is indicated in the lower right-hand corner of the PC
display.
PART 4 - SOFTWARE UTILITIES
Figure 4.1
ULTRALINK™ Data Screen
Data Trend Minutes Data Trend Flow Rate