The burner is operating but the radiators are cold, The domestic hot water does not appear hot enough, Air and water noise in the radiators – DE DIETRICH ECODENS DTG 1300-24 ECO _ V-130 User Manual

Page 14

Advertising
background image

14

DTG 1300-24 Eco / V130

11/09/09 - 300010111-001-B

6. Troubleshooting

6.2.2

The burner is operating but the radiators are cold

„

Air and water noise in the radiators

- Bleed the radiators.
- Top up the heating circuit with water.
- If it is often necessary to top up the installation with water, contact

your fitter.

- If the problem persists, consult your fitter.

„

The burner is operating but the radiators are cold

- Check that the boiler heating pump is operating correctly.
- If the problem persists, consult your fitter.

.

6.2.3

The domestic hot water does not appear hot enough

`

Flow of water from the tap too high. The higher the flow, the
lower the temperature.

- Reduce the flow from the hot water tap.
- If several draw-off points are open at the same time, close one or

other of the points.

6.2.4

Hot water takes a very long time to reach certain draw-off points and not others

This is due to the length of the hot water pipes between the draw-off
points and the boiler. The greater the length, the longer the time
necessary for the hot water to replace the colder water in the pipes.

Advertising