4 operating instructions, 1 starting and stopping the boiler, 1 start the boiler – DE DIETRICH ECODENS DTG 1300-24 ECO _ V-130 User Manual
Page 7: 2 stopping the boiler, 2 changing the settings, 1 selecting the operating mode, 2 changing the heating temperature, 3 changing the domestic hot water temperature, Operating instructions, Start the boiler
7
11/09/09 - 300010111-001-B
DTG 1300-24 Eco / V130
4. Operating instructions
4 Operating instructions
4.1 Starting and stopping the boiler
4.1.1
Start the boiler
1. Check the water pressure in the installation. If necessary, top up
the boiler with water.
The water pressure in the boiler must be between 1.5 and 2 bar.
2. Open the gas valve.
3. Set the 6-position switch T to
(summer mode) or
"
(winter mode).
4.1.2
Stopping the boiler
`
Set the 6-position switch T to
.
(stop / antifreeze / vent). The
boiler goes into standby mode. The display shows " .. ".
In this operating mode, only the boiler is protected against frost.
4.2 Changing the settings
4.2.1
Selecting the operating mode
`
Set the 6-position switch T to the desired operating mode.
-
.
: Stop / Anti-freeze / Bleed.
-
: Domestic hot water (Summer).
-
"
: Heating and domestic hot water (Winter).
4.2.2
Changing the heating temperature
`
Set the temperature of the heating water using button V.
The temperature set in shown on the display.
If using an outside temperature sensor, the heating flow
temperature is adjusted automatically.
4.2.3
Changing the domestic hot water temperature
`
Set the domestic hot water temperature using button X.
The temperature set in shown on the display.