DE DIETRICH ECODENS DTG 1300-24 ECO _ V-130 - Manual (Page 6)

6
DTG 1300-24 Eco / V130 11/09/09 - 300010111-001-B
3. Description
3 Description
3.1 General description
ECODENS boilers are floor-standing gas-fired condensing boilers.
They are combined with a 130 litre tank to handle domestic hot water
production and central heating using radiators or underfloor heating. The boilers can operate on natural gas or on butane/propane. They
are factory set for natural gas H.
3.2 Control panel
C000773-B
N Temperature display The display shows the temperature of the water in the domestic hot water heating outlet when
there is a request for domestic hot water.
O Domestic hot water temperature maintenance
override button
I
With Easymatic remote control:
Pressing the button for 1 second makes it possible to override domestic hot water tank loading
outside the time period programmed in the control unit up to midnight (indicator light O2 flash).
- Light O1 lit : The burner is ignited to reheat the domestic hot water tank.
- Light O2 off : No override or programme running.
- Light O2 lit : Comfort programme activated.
P Safety shutdown light Indicates an error in the boiler.
Q Reset button  To restart the boiler after safety shutdown.
R Button - Used only in measurement V , installer K and sweep M mode.
S Button + Used only in sweep mode M .
T 6-position switch - . : Stop / Anti-freeze / Bleed.
-  : Domestic hot water (Summer).
- " : Heating and domestic hot water (Winter).
- V : Measurement mode (Key to access the parameters reserved for the installer).
- K : Fitter mode (Key to access the parameters reserved for the installer).
- M : Sweeping mode (Key to access the parameters reserved for the installer).
U "Heating" on light The light is on when the heating/domestic hot water reversal valve is in the heating position and the
circulator pump is operating.
V Heating temperature setting Setting range: 30 °C to 90 °C (Hard spot at 68°C).
W Flame presence light The light is on when the burner is operating.
X Setting the domestic water temperature Setting range: 40 °C to 60 °C (Hard spot at 55°C).
Y "Domestic hot water" on light The light is on when the heating/domestic hot water reversal valve is in the domestic hot water
position and the circulator pump is operating.
Z Pressure indicator Indicates the pressure in the heating circuit from 0.5 to 2.5 bar.