FlexLink Configura - Manual (Page 15)

No. of distance (W min/max)
The number of supplementary distance pieces required to widen the distance between the guide rails,
i.e. to give place to wider products on the conveyor. The new, total, measurement (W) between the
guide rails is also given here.
CC distance
The distance between the guide rail brackets when using automatic placement of guide rails (Auto
Guide rail, see below).
Clamp positions – Choose the clamp positions for your bracket type, by checking the corresponding
boxes.
The red arrow points out one out of four possible clamp positions for bracket type A110.
Note:
To activate the text fields below the picture (Free Height, High Clamp Height and Low
Clamp Height), select bracket type High.
Free Height – the distance marked as WH on the image below.
When choosing bracket type High and selecting the two checkboxes, all the text fields are
automatically activated.
Guide Rail
With the Guide Rail component you place guide rails manually, one at a time.
To place a guide rail manually,
1. Move the guide rail close to the conveyor until it snaps to it and click.
2. Continue to click once for each guide rail that you would like to add.
15
© Copyright Configura Sverige AB 2004. All rights reserved. Reproduction, copying or distribution to a third party is prohibited unless
consent in writing has been given by the owner.